Seatbelt rear mounting bracket for convertible
Forum rules
By using this site, you agree to our rules. Please see: Terms of Use
By using this site, you agree to our rules. Please see: Terms of Use
- Mr Spigot
- Minor Fan
- Posts: 164
- Joined: Mon Sep 13, 2021 2:44 pm
- Location: East Sussex
- MMOC Member: Yes
Seatbelt rear mounting bracket for convertible
I want to fit front seatbelts to my 1952 convertible and have all the details about fixing points from the manual (Section R.35). The question I have is where I can obtain a suitable bracket to raise the top mounting so it sits a little higher than just below the bottom of the window sill? I have seen them in photos on the Quickfit website (see below) with a bracket that raises them up a few inches but have been unable to find anything similar. While the obvious answer would be to get Quickfit to fit them, they are nearly a 3 hour drive away and need the car for a full day. I can get a local garage to fit them, but would like to get the mounting points sorted first.
- Attachments
-
- morris-minor-seat-belts.jpg (47.46 KiB) Viewed 913 times
-
- morris-minor-front-seat-belt.jpg (44.64 KiB) Viewed 913 times
-
- morris-minor-convertible-front-seat-belt.jpg (46.65 KiB) Viewed 913 times
1960 2 door with 1275 Midget engine - WOI 577 - owned since 1990
1952 MM convertible with original engine - MWD 305 - owned since 2023
1952 MM convertible with original engine - MWD 305 - owned since 2023
- svenedin
- Minor Legend
- Posts: 1965
- Joined: Fri Aug 29, 2014 9:27 am
- Location: Surrey
- MMOC Member: Yes
Re: Seatbelt rear mounting bracket for convertible
ESM fitted mine for me. My car is a 69 convertible. I can take a few pictures at lunch break if that would help?
Stephen
Stephen
1969 1098cc Convertible “Xavier” which I have owned since 1989.
Stephen
Stephen
- Mr Spigot
- Minor Fan
- Posts: 164
- Joined: Mon Sep 13, 2021 2:44 pm
- Location: East Sussex
- MMOC Member: Yes
Re: Seatbelt rear mounting bracket for convertible
That would be helpful. thanks. Out of interest, how much did they charge?
1960 2 door with 1275 Midget engine - WOI 577 - owned since 1990
1952 MM convertible with original engine - MWD 305 - owned since 2023
1952 MM convertible with original engine - MWD 305 - owned since 2023
- svenedin
- Minor Legend
- Posts: 1965
- Joined: Fri Aug 29, 2014 9:27 am
- Location: Surrey
- MMOC Member: Yes
Re: Seatbelt rear mounting bracket for convertible
OK I have taken some photos. Due to the fact that my car is 1969 it already had front seatbelts from the factory. These were in poor condition and replaced with inertia reel type. I cannot recall what they charged because they fitted rear seatbelts as well and some other jobs too.
Stephen
Stephen
1969 1098cc Convertible “Xavier” which I have owned since 1989.
Stephen
Stephen
- Mr Spigot
- Minor Fan
- Posts: 164
- Joined: Mon Sep 13, 2021 2:44 pm
- Location: East Sussex
- MMOC Member: Yes
Re: Seatbelt rear mounting bracket for convertible
Thanks. Yes that seems to be the conventional fitting, either drilled into the side of the sill with one bolt or bolted underneath with two bolts. I am after a bracket that raises it, so the belt comes down over the shoulder from a slightly higher point, as in my original photos.
1960 2 door with 1275 Midget engine - WOI 577 - owned since 1990
1952 MM convertible with original engine - MWD 305 - owned since 2023
1952 MM convertible with original engine - MWD 305 - owned since 2023
- Bill_qaz
- Minor Addict
- Posts: 711
- Joined: Fri Jan 14, 2022 7:31 pm
- Location: Oxfordshire
- MMOC Member: Yes
Re: Seatbelt rear mounting bracket for convertible
https://www.ebay.co.uk/itm/176250020414 ... media=COPY
Would something like this work for you, the supplier says they do various so maybe worth messaging
Would something like this work for you, the supplier says they do various so maybe worth messaging
Regards Bill
- Mr Spigot
- Minor Fan
- Posts: 164
- Joined: Mon Sep 13, 2021 2:44 pm
- Location: East Sussex
- MMOC Member: Yes
Re: Seatbelt rear mounting bracket for convertible
Thanks, that is getting closer. I will see what he can do.Bill_qaz wrote: ↑Mon Mar 04, 2024 5:25 pm https://www.ebay.co.uk/itm/176250020414 ... media=COPY
Would something like this work for you, the supplier says they do various so maybe worth messaging
1960 2 door with 1275 Midget engine - WOI 577 - owned since 1990
1952 MM convertible with original engine - MWD 305 - owned since 2023
1952 MM convertible with original engine - MWD 305 - owned since 2023