Traveller Restoration

[jagnut66]

He's doing a very good job though, just shows what can be done, if you put your mind to it.

[Wyliecoyote]

Top work and great photos, I think we have equally rusty Minors!

[Neil MG]

Let's see, where were we...Just cut out the rot from the bottom of the kidney panel[frame][/frame]

[Neil MG]

Dressed the edge to make sure there is good clean metal...[frame][/frame]

[Neil MG]

And a cardboard template...[frame][/frame]

[Neil MG]

Is made in steel and secured in position...[frame][/frame]

[Neil MG]

before being tacked...[frame][/frame]

[Neil MG]

And welded into place.[frame][/frame]

[Neil MG]

The welds are dressed and the boxing panel welded on ready to trial fit the inner wing...[frame][/frame]

[Neil MG]

Those welds are dressed and the inner wing is tacked in place...[frame][/frame]

[Sparticus]

This is mental..i'm so envious of your welding..and speed! It's the only thing holding me back from carrying on with mine

[Neil MG]

Wire brush, rust converter, chassis black and edges dressed ready for the inner wing panel...[frame][/frame]

[rogerowen]

Is made in steel and secured in position...[frame][/frame]

I like the holding pegs - are they Frost ones?

[brucek]

Seriously neat welding - the car will be a stunner when completed. Enjoying the updates too. Thanks

[Neil MG]

Which is duly welded in place...[frame][/frame]

[Neil MG]

And dressed off. The front parts are not welded up yet as I will check the grill alignment etc...[frame][/frame]

[Neil MG]

Need to finish welding the floorpan...[frame][/frame]

[Neil MG]

and dressed...[frame][/frame]

[Neil MG]

Then the front outer floor repair panel can be prepared...[frame][/frame]

[Neil MG]

And fitted...[frame][/frame]