Morris Minor Owners Club

I think it was some time ago some one on here had put a smaller steering wheel on their minor and had fitted a new horn button in the middle of the steering wheel. I am just trying to find the pictures as friend has a minor and wants to do the same to his.

I have since change the wires going to the alternator and now find that the oil light is now staying onall the time. When the car is ticking over the light is on dim and when I speed the engine up the light goes brighter. The ignition light is still not working.. Please could some one please give me...

Hi hope some one can help. I changed the spark leads on my car and when I went to start the car I found that the ignition light had stopped working the car starts and runs fine. I have checked all the wiring and it seens ok and the ignition light bulb has been changed. While the engine has been runn...

You could also try and put Remote deadlock central locking. I have on mine and it does really work.

Hi does any one know have a good garage in Uxbridge area that knows how to MOT morris Minors?

Hi I seem to have a flat spot after I start my car. It start ok but when I press the accelerator there seems to be a flat spot. I have checked the valve clearances and they are ok, oil in the piston damper is ok as well. So what should I check next?
Thanks

Hi I am trying to fit poly bushs intothe rear spring where it goes in the the front spring hanger on the body of the car and I just can not get then to go in. Can some one tell me an easy way to get them to fit. I had only put rubber bushs in 8 months ago and when I checked them them were already on...

Can a Morris Ital van gearbox be used with Ital engine in a morris minor?

Thanks for the ideas and help one thing I am worried about is the thickness of the inlet manifold and the exhaust manifold.when bolted to the engine. A friend had a lot of trouble as there was a different of about eight of an inch between the too.

Hi,
I want to put an HS4 carburettor on my minor I need to know which inlet manifold can I use with a minor exhaust manifold that has had the inlet manifold cut off.

I have just got hold of a Morris minor steering column with column mounted switch and steering lock and I want to fit it to my 1971 2 door minor. Do I just run the wires from my old switch or is there more to it than just that. Will the pin numbers be the same on both switches?

A friend wants to put a 32/36 carb on this Morris Minor but is not sure what the jet set up should be. Any one have any idea?
Thanks

Sorry if by asking this question it has up set any one.

I have to put a switch into my 2 door Morris Minor but I am not sure which is the best way to do it, can any one give me some ideas

I have been changing the the rubber bush's on the eye bolt on the front right suspension with my son and had moved the rear lower rear arm back and i did not mark it as it was still on the edge of the torsion bar. I went to answer a phone call and when I back i found that some how he had remove the ...

Hi I have been reading about greasing the steering rack but no where does it say how much grease to use on the rack.
can some one please give me an ides of how much to use.
Thanks

I just want to say thank you for all the help given on here. I am not sure just what was wrong back having tried what people on here have said they are now both working.
Once again thank you for your help.

Thank you I will have a look at that tomorrow, the fuel gauge is working ok.

Hi I hope some one can help me, I have non working wipers and heat motor. There are three wires on the wiper motor, and on the wiper switch there are also three wires one of which seems to go to the heat motor switch. There does seem to be power at the wiper motor and switch but it they both are sti...

Hi can any one tell me the inside diameter of a morris minor top hose.
Thanks.