Morris Minor Owners Club

Hi
Need help
I have just bought headlamp guards for my moggie and I am having bother fitting them. I have headlamp peaks on the car already and would also like to fit these guards
I would appreciate any advice on how to fit these guards.
Cheers Andy Pandy

Can anyone help I have a 1958 with the 948cc engine Morris with the oil bath air filter which keeps working it,s way up the air pipe to carburettor. The rubber sleeve which is on it would seem to be the original one and is in a poor state and needs to be replaced. I ordered one from Moss but what wa...

I am looking for the lower cover which fits on the under side of the indicator switch on my 1958 minor.
It covers the wiring it is about 3 x 1.5 inches and has radius at one end and a cut out at the other and has a hole for the securing screw to go through.

The door frame on the leading edge of the door and the bottom frame that the cover screws onto .Both are about 5/8 square. By marking the width of these along with the rubber seal position onto the outer side of the cover in pencil it allows you to position the plain washer for marking off the hole.

Remove the triangular cover at the bottom of the quarter light. Carefully mark in pencil the width of the door frame on the front and bottom of the cover. Having removed the cover you will see where the window rubber seal ends, again mark this onto the cover, you will then see the area that you can ...

Hi I am trying to locate the lower cover of the indicator/horn switch for a 1958 minor,it is approximately 3 inches long x 11/2 wide round at one end if there was one on any of these scrappers could you possibly ask if you could get it and it would just finish of my car.
Regards AndyPandy

Thanks for all replies to my request
Regards AndyPandy

Trying to trace 1958 2 door dark green with white leather interior 948cc Morris minor REG No SGE927

Sparesman can you just post a list of the toolkit then everyone can see it

taken from Original Morris Minor by Ray Newell, page 68 Up to car number 848240, the following items were supplied in a canvas tool roll: starting handle/wheelbrace, triangular type jack, hupcap remover, small tyre lever, tommy bar, plug spanner, screwdriver, tyre valve spanner, tappet feeler gauge...

[Can anyone help I am trying to find what the original tool kit contained that was supplied with 1958 Morris 1000.

Trying to locate 1958 Dark green Morris 1000 Reg No SGE 927

Need help to find what was the original tool kit supplied with 1958 Morris 1000