Morris Minor Owners Club

i enjoyed that

i think my engine runs smoother on higher octane fuel

yes you can do it , i had no problems

try backing of the timing a little

the coils from distriubter doctor or accuspark are good

i have got accuspark on my car works fine

i have a hif38 on my 1098with 1275 head and maniflow exhaust thats plenty

i had a breakdown on the m25 managed to pull onto the hard shoulder the wire had come out of the spade connector fitted a new connector and crimped it down went home repair took me 30 seconds its worth carring a few odds and ends to get you home

i had an allegro when i was 18 was off the road more than it was on

i would say going to esm would be a good point of call , i have not baught a car from them , buti have got parts and they are top quality sounds like you are doing your homework . they can advise you on what to look for . dont worry about the bodywork too much a solid foundation is the key, you can ...

not wishing to be smug ive got the origional tap it works fine for me , there have been bad heater valves for years now i would rather pay a bit more and have something that works

let us know how things are going after a bit of running around as long as there are no bottem end knocking sounds you should be ok for a while .

well if its 6 months old i would be sending it back or at leas phoning them up , im getting the impression the qualiaty of the parts they are getting is not as good as it once was , my red coil has done 3 years now , and i do carry a spare

sounds like you could do with a new pump they are easy to change and have electronic innards that are more reliable , all the morris minor suppliers as well as burlon fuel systems

check the mainfold clamp is there a leak between the manifold and the down pipe it might need some gun gum round the joint

have you tryed flushing out the hearer there might be a load of gunge lurking in there i had this when i had an engine change its easy to flush out

malta , love it there

sorry did not read it correctally

do the wheelcylinders slide up and down freely on the backplate

it you want decent replacement points or condencers go to distributer doctor