Morris Minor Owners Club

Hi all
can anyone shed any light on the thread on the fuel tank to fuel pipe( or fitting type)
an on the other end of the fuel pipe which attaches to the fuel pump ??
cheers Stu

ok guys thanks for the info and advice

Hi all yet another questions for all you wizards of knowledge replaced old engine with a rebuilt 1275 and box firstly the engine was removed on its own ie remove l/h engine mount and turn engine 90 degrees and take out no problem so far then gearbox out again no real problems there new engine in and...

hi all
manged to get the two together with a bit of help from a mate many thanks for all the advice what a royal pain it was but all sorted
again cheers all

i have a 1275 midget going into the morris over this week and looking for advice for the breather set up it has the cannister on the front timing chain cover and one fitted to the block (i assume where to mech fuel pump would have been fitted) rocker cover doesn't have a pipe for the hose and im hop...

i have just looked on ebay and the clutches list show a clutch with a printed message saying 'flywheel side'
seen here
wheres mine says gearbox side

hi mate
it could be down to the dodgy camera work ! the clutch tool slides in ok right up to the end (4th and 5th pics)

ok hope these help

Hi all having a slight problem fitting a 1275 gearbox(mg midget) to a 1275 (midget as well) engine the box goes on so far and then it stops just short of the locating dowels on the back plate removed clutch and fit box no problem checked clutch on output shaft of box all ok aligned the clutch with t...

i just a quick question ..... planning to remove engine and box soon to replace with rebuilt ones can i /is it possible to remove old engine box as one unit without removing front panel/grill etc have engine hoist and hydraulic ramps to lift the front end up jag4.jpg or is it better to split the old...

Cheers i thought that's what they were but had better check

anyone tell me what the thread is on the mounting studs for the carb??
and is it the same on all the "a" series inlet manifolds??
as I'm using a twin carb set up from a midget 1275 but need longer studs (to fi poss twin spacers) to miss the maniflow exhaust manifold
cheers

hi all
looking to fit a 1.5inch carb to my 948cc minor any suggestions to the needle?
cheers
Stu

hi
i used a set of Alfa 147 seats in my 2dr

Many thanks to all who replied to my post

thanks
but i have a pump but didn't want to use a adjustable on it i would rather use a proper spanner

hi all
looks like the fuel pump is on its last legs!
what size is fuel pipe nut to the pump is ????
cheers
Stu

great !! many thanks

Hi all
any idea what the thread is on the oil filter housing studs are??(screw on type housing)
Stu