- 566F25A3-971A-475D-9D82-E6CA29876EDB.jpeg (2.16 MiB) Viewed 696 times
Bulkhead plates
Forum rules
By using this site, you agree to our rules. Please see: Terms of Use
By using this site, you agree to our rules. Please see: Terms of Use
Bulkhead plates
I’m not sure which plates should be present in the attached photo, I presume the one shown is correct but there are holes for another, can someone enlighten me please? Sorry for the poor picture quality
-
POMMReg
- Minor Legend
- Posts: 3023
- Joined: Mon Jun 07, 2010 6:17 pm
- Location: Gloucester
- MMOC Member: No
Re: Bulkhead plates
Les
Below not used on later Hm.Mkt LCVs, when vin plate attached to the nsf cab dr card.
Below not used on later Hm.Mkt LCVs, when vin plate attached to the nsf cab dr card.
Further investigations uncovered it was an inside job!!
Re: Bulkhead plates
Chris, I have Vin plate on nsf door card. Please clarify the bulkhead plate situation, are you saying there should be no plates on bulkhead, if so, why are there holes there for two plates.?
-
POMMReg
- Minor Legend
- Posts: 3023
- Joined: Mon Jun 07, 2010 6:17 pm
- Location: Gloucester
- MMOC Member: No
Re: Bulkhead plates
Holes there for export models.
Hm.Mkt with just the single plate with BS1965 guff on it.
Hm.Mkt with just the single plate with BS1965 guff on it.
Further investigations uncovered it was an inside job!!