Rear heated window (Traveller)
Forum rules
By using this site, you agree to our rules. Please see: Terms of Use
By using this site, you agree to our rules. Please see: Terms of Use
-
- Minor Fan
- Posts: 422
- Joined: Tue Sep 01, 2015 10:37 am
- Location: East London
- MMOC Member: Yes
Re: Rear heated window (Traveller)
resurrecting this thread slightly. I've been contemplating putting in some heated rears on my mog, but last year when I was replacing the sealant on the windows, I was stumped at how the glass can be removed. I removed all of the fillets on left, right and bottom pieces, but the top piece of wood appeared to be solid with no screw to remove. was I being an idiot and you're just meant to pull the glass down to remove?
-
- Minor Legend
- Posts: 2765
- Joined: Tue Nov 11, 2014 9:41 am
- MMOC Member: No
Re: Rear heated window (Traveller)
The top piece has a slot cut into it to retain the glass. The glasses are simply slid up into that slot from beneath and the 3 fillets retain it in position. As you say, the glass has to be sealed all the way round
It was probably just old sealer which was holding the glass in position.
It was probably just old sealer which was holding the glass in position.
- twincamman
- Minor Fan
- Posts: 425
- Joined: Thu May 10, 2007 12:22 pm
- Location: Llanelli
- MMOC Member: No
Re: Rear heated window (Traveller)
You might find this useful:-
https://www.12voltplanet.co.uk/12v-univ ... delay.html
https://www.12voltplanet.co.uk/12v-univ ... delay.html
-
- Minor Legend
- Posts: 2147
- Joined: Mon May 10, 2004 9:10 pm
- Location: Oxford, UK
- MMOC Member: Yes
Re: Rear heated window (Traveller)
Going back to the earlier part of this thread, and whether to use a relay or not, is the current draw of ~6A for the Traveller rear heated screen for each screen, or for both screens in total? With a total of 6A you could probably get away with a switch, but I would not, and if it is 6A per each screen, i.e. a total of 12A, then both a relay AND suitable size cables are definitely needed. For 12A the cable should be 28/0.012 (imperial), 28/0.30 (metric) or a minimum of 1.50 sq mm if using the cross-sectional area measurement.
Richard
-
- Minor Fan
- Posts: 228
- Joined: Wed Oct 13, 2010 7:24 pm
- MMOC Member: No
Re: Rear heated window (Traveller)
I fitted heated rear screens to both rear doors on my traveller, and a heated windscreen. Used an illuminated centre off two way with via relays so that both front and rear couldn't be on at the same time and put too much strain on the electrics 9charging etc) front screen only needs to be on for a short time anyway to defrost etc.
I would definitely use relays...
I would definitely use relays...