Could someone please point(pun not intended) me in the right direction for a set of
points and a condenser for my 1952 Morris Series 2.
Thanks
Shane
Bits Needed
Forum rules
By using this site, you agree to our rules. Please see: Terms of Use
By using this site, you agree to our rules. Please see: Terms of Use
-
- Minor Legend
- Posts: 1565
- Joined: Fri Aug 05, 2011 9:53 pm
- Location: Leeds, West Yorkshire
- MMOC Member: No
Re: Bits Needed
Distributor Doctor for the most reliable parts for ignition.
http://www.distributordoctor.com
http://www.distributordoctor.com
Richard
Opinions are like people,everyone can be different.
Opinions are like people,everyone can be different.
Re: Bits Needed
And get a new rotor arm at the same time.... And test the vacuum advance - if it has failed (more than likely unless replaced in the last 20 years) get a new one too!
Re: Bits Needed
Thanks for the help and advice
Shane
Shane
-
- Series MM Registrar
- Posts: 10183
- Joined: Sun Jul 24, 2005 11:39 pm
- Location: Reading
- MMOC Member: No
Re: Bits Needed
Are you sure it is a 1952 Series II? As far as I am aware all the 1952 Series IIs were exported, 1952 cars in this country were Series MMs
[sig]3580[/sig]
Re: Bits Needed
Slip of the keyboard it's a 1953
-
- Series MM Registrar
- Posts: 10183
- Joined: Sun Jul 24, 2005 11:39 pm
- Location: Reading
- MMOC Member: No
Re: Bits Needed
Your distributor should be a DM2 although later M1000 25D distributors will fit.
[sig]3580[/sig]