indicator bulb ignition

[markattard]

hi what is the proper tool to tighten this indicator bulb in a series II please?

[Shropshiremoggie]

I used to use a pair of long nosed pliers , inserting the ‘ noses ‘ into the two slots in the bezel and rotating it gently . Maybe not the correct tool —— but it worked for me

[geoberni]

That's a common type of fitting of the era, not just on cars but even on aircraft.
The original tool would have been a fine wide flat blade screwdriver with a slot machined in it.

A bit like this: https://toolsforworkingwood.com/prodimg ... T-SNSD.gif

But a set of fine long nose pliers woks pretty well

[bufferzone]

https://mossmotors.com/bezel-remover-tool-set

[jagnut66]

Hi,
Same bezel removing set as above but cheaper than Moss.
Best wishes,
Mike.

https://www.googleadservices.com/pagead ... BBY&adurl=

[JOWETTJAVELIN]

I used to use the end of a steel ruler.