Oil filter seals
Forum rules
By using this site, you agree to our rules. Please see: Terms of Use
By using this site, you agree to our rules. Please see: Terms of Use
-
- Newbie
- Posts: 1
- Joined: Mon Feb 03, 2003 8:18 pm
- MMOC Member: No
Oil filter seals
How often have you put on a new filter, only to find that thin seal has not stayed in the right place and is useless. Try this for a cure, wipe the outside of the oil filter holder with a dry cloth and with the new filter inside the cannister wrap a 1/2" wide piece of masking tape around the top of the cannister with a 1/16" overlap. Put the filter ring on the top of the cannister, inside the thin lip of masking tape and now screw the new filter into place. Just before finally tightening with a spanner or socket peel off the masking tape - then tighten. Works like a dream!
-
- Moderator
- Posts: 7592
- Joined: Thu Feb 14, 2002 12:00 am
- Location: Watford, Hertfordshire.
- MMOC Member: No
Sorry to be a pain but is there any chance of a diagram to explain how this works as I normally try to stick the seal in place with some oil before I screw up the filter assembly, or has anyone else any imput
Cheers
Kevin
Lovejoy 1968 Smoke Grey Traveller (gone to a new home after13 years)
Herts Branch Member
Moderator MMOC 44706
Kevin
Lovejoy 1968 Smoke Grey Traveller (gone to a new home after13 years)
Herts Branch Member
Moderator MMOC 44706
-
- Moderator
- Posts: 7679
- Joined: Fri Nov 01, 2002 2:55 pm
- Location: LEAMINGTON SPA
- MMOC Member: No
I use some oil on the new seal to hold it in place too. Then (holding one side in with a finger) I go round the seal pushing it fully home with a thin bladed screwdriver.
That works as long as you do it just before fitting the cannister. Any more than a few minutes and it tends to fall out.
That works as long as you do it just before fitting the cannister. Any more than a few minutes and it tends to fall out.
Ray. MMOC#47368. Forum moderator.
Jan 06: The Minor SII Africa adventure: http://www.minor-detour.com
Oct 06: back from Dresden with my Trabant 601 Kombi
Jan 07: back from a month thru North Africa (via Timbuktu) in a S3 Landy
June 07 - back from Zwickau Trabi Treffen
Aug 07 & Aug 08 - back from the Lands End to Orkney in 71 pickup
Sept 2010 - finally gave up breaking down in a SII Landy...
where to break down next?
2013... managed to seize my 1275 just by driving it round the block
Jan 06: The Minor SII Africa adventure: http://www.minor-detour.com
Oct 06: back from Dresden with my Trabant 601 Kombi
Jan 07: back from a month thru North Africa (via Timbuktu) in a S3 Landy
June 07 - back from Zwickau Trabi Treffen
Aug 07 & Aug 08 - back from the Lands End to Orkney in 71 pickup
Sept 2010 - finally gave up breaking down in a SII Landy...
where to break down next?
2013... managed to seize my 1275 just by driving it round the block