Hi all
I am about to grind the valves on my side valve engine as one of the cylinders was down on pressure, is there a surefire way to put the valve cotters back in place if the engine is still installed in the car,or would it be easier to take engine out and put it on the bench as i will also have to do the tappet clearances and i know that is a job that is difficult enough .
Ian
valve cotters
Forum rules
By using this site, you agree to our rules. Please see: Terms of Use
By using this site, you agree to our rules. Please see: Terms of Use
-
- Minor Legend
- Posts: 3287
- Joined: Tue May 20, 2008 9:24 pm
- Location: Co.Mayo Ireland
- MMOC Member: Yes
-
- Minor Friendly
- Posts: 54
- Joined: Tue Jul 19, 2011 11:27 am
- Location: Melbourne, Australia.
- MMOC Member: No
Re: valve cotters
You will have moved on from this need, but I thought the cotters were just stuck into place with a little grease, while you take the tension off the spring/lower the valve cap.
BTW, did you overcome the need for re-hardened tappet bolts? I have quite a few worn/indented ones here, in Melbourne, Australia.
BTW, did you overcome the need for re-hardened tappet bolts? I have quite a few worn/indented ones here, in Melbourne, Australia.
-
- Minor Legend
- Posts: 3287
- Joined: Tue May 20, 2008 9:24 pm
- Location: Co.Mayo Ireland
- MMOC Member: Yes
Re: valve cotters
Hi
Thanks for asking.
Yes put grease on screwdriver tip to replace cotters, its harder to fit the first cotter then swing around the back and fit second,the first screwdriver had slight magnetism which meant the cotter would not leave screwdriver tip so had to find another. I bought original type spring compressor as modern one wont work.
I have a spare set of bolts but they are all worn as well, when i came to do tappet gaps I took a couple of thou off settings, ran engine any noisy tappets took another thou off setting and l ran the engine again, all quiet now.
Ian
Thanks for asking.
Yes put grease on screwdriver tip to replace cotters, its harder to fit the first cotter then swing around the back and fit second,the first screwdriver had slight magnetism which meant the cotter would not leave screwdriver tip so had to find another. I bought original type spring compressor as modern one wont work.
I have a spare set of bolts but they are all worn as well, when i came to do tappet gaps I took a couple of thou off settings, ran engine any noisy tappets took another thou off setting and l ran the engine again, all quiet now.
Ian
-
- Minor Addict
- Posts: 621
- Joined: Wed Sep 05, 2012 9:32 pm
- Location: East Yorkshire
- MMOC Member: Yes
Re: valve cotters
I must admit at my age, 80 , I find it easier to take the engine out with my stacker truck and work on it on the bench. Set tappets, remove sump and clean, check bearings and back in again same day. Good for a couple of years then.!!
-
- Minor Friendly
- Posts: 11
- Joined: Tue Dec 26, 2017 4:59 pm
- MMOC Member: No
Re: valve cotters
Yes, My mate Geoff with an MM two months newer than mine have jointly agreed that taking the engine out makes life much easier. But we double and triple check all the gaps and ensure all is tightened well before putting the engine back in. I also have an engine lift which helps!
Colin
Colin