Page 1 of 1

Quick restoration job :)

Posted: Mon Jun 06, 2016 8:56 am
by lisadavee
A quick restoration job due to redundancy lol , everything done now apart from brakes on drivers side front , needs new cylinders but cannot the the bolts of the old ones , any advise please don't think they have been changed since it was made lol x[frame]Image[/frame][frame]Image[/frame][frame]Image[/frame][frame]Image[/frame]

Re: Quick restoration job :)

Posted: Mon Jun 06, 2016 3:39 pm
by davidmiles
I do like that colour tone seperation,very subtle and have to say, classy looking.

Re: Quick restoration job :)

Posted: Wed Jun 15, 2016 8:13 pm
by firehor5e
Try cleaning with a wire brush, loads of plusgas,soak over night,another soak..try to move the offending bolt a little TIGHTER,as this may break the bond it has made and if you do slip and round off the bolt it will still have a good surface area on the "undo "parts of the head.Allways use a decent fitting tool,socket preferably,or ring spanner.Once the bolt yields,keep up the lubrication and dont try to remove it in one undo do up undo etc. If the cylinders are scrap,try a blowlamp if its safe to do so.