Hi,
I have replaced top and bottom trunions. Put in poly bushes to top. Is there supposed to be a gap between the washer and bush. Looking in the manual supposed to be .20 inch but not sure if this is right with poly bush set up.
Also how tight should I do the top and bottom nuts, is there a torque wrench setting?
Thanks
Rob
trunions
Forum rules
By using this site, you agree to our rules. Please see: Terms of Use
By using this site, you agree to our rules. Please see: Terms of Use
-
- Minor Fan
- Posts: 106
- Joined: Sun Oct 25, 2015 3:36 pm
- Location: Sidmouth Devon
- MMOC Member: No
-
- Minor Maniac
- Posts: 10816
- Joined: Thu Jul 19, 2012 12:05 pm
- Location: Hampshire
- MMOC Member: Yes
Re: trunions
There should be no gap.
The reference to 0.20" refers to the screwed top trunnions that have been replaced by the rubber/poly bushes.
There is no torque setting for the nuts. Just do up tight.
The reference to 0.20" refers to the screwed top trunnions that have been replaced by the rubber/poly bushes.
There is no torque setting for the nuts. Just do up tight.
-
- Minor Fan
- Posts: 106
- Joined: Sun Oct 25, 2015 3:36 pm
- Location: Sidmouth Devon
- MMOC Member: No
Re: trunions
Okay thanks for that Phil