Hi All
Long story short, I’ve lost the instructions to fit my servo. ESM sent me a diagram for the pipe work but could do with some instructions for the fitting. Any help, photos etc would be great. Many thanks
ESM servo instructions
Forum rules
By using this site, you agree to our rules. Please see: Terms of Use
By using this site, you agree to our rules. Please see: Terms of Use
-
- Minor Fan
- Posts: 468
- Joined: Thu May 11, 2017 8:23 pm
- Location: South Cheshire
- MMOC Member: Yes
Re: ESM servo instructions
This was originally done by Declan Burns
- Attachments
-
- untitled1.png (209.96 KiB) Viewed 728 times
-
- Minor Fan
- Posts: 468
- Joined: Thu May 11, 2017 8:23 pm
- Location: South Cheshire
- MMOC Member: Yes
Re: ESM servo instructions
Sorry, I can only do one at a time!
- Attachments
-
- Disc%20Brake%20Kit%20p1.jpg (291.01 KiB) Viewed 728 times
-
- Minor Fan
- Posts: 468
- Joined: Thu May 11, 2017 8:23 pm
- Location: South Cheshire
- MMOC Member: Yes
Re: ESM servo instructions
Is it possible to add a PDF file? Or can you PM me your email address and I will send the Lockheed fitting instructions.
Re: ESM servo instructions
Very many thanks for this. Just one more question, do you mount it on the bulk head?
-
- Minor Fan
- Posts: 468
- Joined: Thu May 11, 2017 8:23 pm
- Location: South Cheshire
- MMOC Member: Yes
Re: ESM servo instructions
Mine is mounted on the drivers side engine bay tie plate. I think that this will mean removing the distributor when I need to remove the starter motor. I have also seen one mounted under the drivers seat. Try to avoid anywhere that may get hot (near the exhaust).