Hi all
One of my Moggies has a rotten rear floor, but not the area where peoples feet go (you can get panels for there easily enough) but back from the cross box under the rear seat, round front rear spring hanger and right across into the transmission tunnel, all on the drivers sidde. Basically a huge area is all just holes and underseal. The rest of the floor is fine, nothing wrong with that. I have the spring hanger on a plate but the rot is over a far larger area than this covers. Does anyone know of any pressings for that whole area? I couldnt find any.
Rear floor pans
Forum rules
By using this site, you agree to our rules. Please see: Terms of Use
By using this site, you agree to our rules. Please see: Terms of Use
-
- Minor Friendly
- Posts: 75
- Joined: Sun Dec 08, 2013 3:05 pm
- MMOC Member: No
Re: Rear floor pans
hallo dave, i dont know about pressings,but having just replaced f/ward spring hanger and gone through a migraine placing correctly hanger plate be warned do not lose rivet holes in floor under rear seat,datum points. re, john.
-
- Minor Friendly
- Posts: 89
- Joined: Sat Dec 14, 2013 8:37 pm
- Location: East Anglia
- MMOC Member: No
Re: Rear floor pans
Made these areas with a hammerform
- Attachments
-
- DSC01126.JPG (582.46 KiB) Viewed 1016 times
-
- DSC01183.JPG (600.51 KiB) Viewed 1016 times
-
- Minor Friendly
- Posts: 41
- Joined: Thu Jul 30, 2015 11:29 am
- MMOC Member: No
-
- Minor Legend
- Posts: 2646
- Joined: Thu May 11, 2006 10:34 am
- Location: Cardiff
- MMOC Member: Yes
Re: Rear floor pans
Similar technique, albeit using a couple of flat bits of steel sheet instead of a properly dimensioned template.
Cardiff, UK