Page 1 of 1

Scuttle / Kick Panel Installation Advice

Posted: Sun Oct 21, 2018 11:52 am
by MichaelBeck
Hi Guys

I have new scuttle / kick panels. I see the loose flap of material that will be secured by the draught strip and the parcel shelf screws. Are there any other securing fixtures for the panels or is that it & it is held in by the carpet at the bottom?

Re: Scuttle / Kick Panel Installation Advice

Posted: Sun Oct 21, 2018 12:52 pm
by RobThomas
Not sure of the age of your car, but, Series MM had 3 screws vertically lined up about an inch in from the draught excluder and then at the front by the parcel shelf. Not 100% sure the little flap was used on the original cars. Someone into later cars might help on this.

Re: Scuttle / Kick Panel Installation Advice

Posted: Sun Oct 21, 2018 6:11 pm
by myoldjalopy
Its the same on mine - 1955 SII. I think thats pretty standard.........don't think any flaps were secured under the draught excluder, just glued to the back of the panel.

Re: Scuttle / Kick Panel Installation Advice

Posted: Tue Oct 23, 2018 1:24 am
by irmscher
Just glued