Hi Guys
I have new scuttle / kick panels. I see the loose flap of material that will be secured by the draught strip and the parcel shelf screws. Are there any other securing fixtures for the panels or is that it & it is held in by the carpet at the bottom?
Scuttle / Kick Panel Installation Advice
Forum rules
By using this site, you agree to our rules. Please see: Terms of Use
By using this site, you agree to our rules. Please see: Terms of Use
-
- Minor Friendly
- Posts: 24
- Joined: Thu Dec 26, 2013 2:35 am
- MMOC Member: No
-
- Minor Legend
- Posts: 2646
- Joined: Thu May 11, 2006 10:34 am
- Location: Cardiff
- MMOC Member: Yes
Re: Scuttle / Kick Panel Installation Advice
Not sure of the age of your car, but, Series MM had 3 screws vertically lined up about an inch in from the draught excluder and then at the front by the parcel shelf. Not 100% sure the little flap was used on the original cars. Someone into later cars might help on this.
Cardiff, UK
-
- Minor Legend
- Posts: 2533
- Joined: Tue Jan 29, 2013 10:32 pm
- Location: Kernow
- MMOC Member: Yes
Re: Scuttle / Kick Panel Installation Advice
Its the same on mine - 1955 SII. I think thats pretty standard.........don't think any flaps were secured under the draught excluder, just glued to the back of the panel.
-
- Minor Legend
- Posts: 3773
- Joined: Wed Jul 14, 2010 10:53 am
- Location: South Manchester
- MMOC Member: Yes
Re: Scuttle / Kick Panel Installation Advice
Just glued