Front lower rebound check
Posted: Mon Dec 03, 2012 10:10 pm
Hi,
I was asked to copy this into here, I hope it helps anyone with a similar dilemma to what I faced when I discovered that my 'new' replacement from a 'main supplier' would not fit no matter how much I tried to 'persuade' it to.....
and then that the consensus of opinion was that the remade replacements for this part (from whichever supplier) are generally rubbish!!
This is now made up and fitted using a Mini exhaust bobbin and the original bracket, as decided earlier (see other post in 'mechanical').
Unfortunately I couldn't get two mounting rubbers out of one bobbin as they would have been too thin, so I cut them just below the metal fixing plate on one side, as shown below:[frame][/frame]
This made them pretty much the same thickness as the original. I then drilled a hole in the fixing bracket, very slightly off centre:
[frame][/frame]
I then bolted my new home made bump stop into place, you will notice the fact that it sits to one side of the bracket, once on the car you will see how this makes sense, as the shock absorber arm is angled towards the rear of the car.[frame][/frame][frame][/frame]
I then sprayed on a coating of underbody seal / waxoil and I was done.
Until the next one goes...........................
Best wishes,
Mike.
I was asked to copy this into here, I hope it helps anyone with a similar dilemma to what I faced when I discovered that my 'new' replacement from a 'main supplier' would not fit no matter how much I tried to 'persuade' it to.....
and then that the consensus of opinion was that the remade replacements for this part (from whichever supplier) are generally rubbish!!
This is now made up and fitted using a Mini exhaust bobbin and the original bracket, as decided earlier (see other post in 'mechanical').
Unfortunately I couldn't get two mounting rubbers out of one bobbin as they would have been too thin, so I cut them just below the metal fixing plate on one side, as shown below:[frame][/frame]
This made them pretty much the same thickness as the original. I then drilled a hole in the fixing bracket, very slightly off centre:
[frame][/frame]
I then bolted my new home made bump stop into place, you will notice the fact that it sits to one side of the bracket, once on the car you will see how this makes sense, as the shock absorber arm is angled towards the rear of the car.[frame][/frame][frame][/frame]
I then sprayed on a coating of underbody seal / waxoil and I was done.
Until the next one goes...........................
Best wishes,
Mike.