Hi at all. I have this problem. I put on my traveller a new wiring loom suitable for alternetor. Now as you can see by photos I have: a black and white wire to connect to the coil and another black and white wire to connect to the the distributor. But as you can see from distrubutor I have two wires and not only one because I put on my car an electronic Ignition Kit – Lumenition (Magnetronic). So where I must put black and white wire? To the red or to the black wire to join distributor. Then I have a wire more, what I must do for it?
Thanks, Max from Italy[frame][/frame][frame][/frame]
distributor problem
Forum rules
By using this site, you agree to our rules. Please see: Terms of Use
By using this site, you agree to our rules. Please see: Terms of Use
-
- Minor Friendly
- Posts: 32
- Joined: Sat Dec 01, 2012 9:21 pm
- MMOC Member: Yes
-
- Minor Legend
- Posts: 2217
- Joined: Mon Nov 15, 2010 11:44 pm
- Location: West Midlands UK
- MMOC Member: No
Re: distributor problem
The red wire from the electronic ignition should go to the + side of the coil, and the black wire from the electronic ignition should go to the white wire with a black trace. That white wire with black trace then goes onto the - side of the coil.
-
- Minor Friendly
- Posts: 32
- Joined: Sat Dec 01, 2012 9:21 pm
- MMOC Member: Yes
Re: distributor problem
Hello, many thanks for your super quick reply.
Max
Max
-
- Minor Friendly
- Posts: 32
- Joined: Sat Dec 01, 2012 9:21 pm
- MMOC Member: Yes
Re: distributor problem
Hello, so if I understand in the positive side of the coil I have two wires: the red wire from distributor and the only White wire drom the wiring loom.
Thanks,
Thanks,