I REPLACED MY STUDS WHEN I DONE VALVES (200MILES AGO) THE CENTRE SHORT ONE HAS SNAPPED THEY WERE ALL TIGHTENED TO CORRECT TORQUE
(50 YEARS IN MOTOR TRADE) WHERE CAN I BUY DECENT STUDS NOT MADE FROM CHINESIUM!!!!!!!!
HEAD STUDS
Forum rules
By using this site, you agree to our rules. Please see: Terms of Use
By using this site, you agree to our rules. Please see: Terms of Use
-
- Minor Friendly
- Posts: 15
- Joined: Thu Jun 20, 2019 9:20 pm
- MMOC Member: No
- svenedin
- Minor Legend
- Posts: 1960
- Joined: Fri Aug 29, 2014 9:27 am
- Location: Surrey
- MMOC Member: Yes
Re: HEAD STUDS
If you can find them second hand you can use the A plus studs and flanged nuts. These studs are marked with a "Y" symbol on the pointed top. The standard studs are torqued to 42 ft lbs. The high tensile ones can be torqued a bit higher if you need to.
Standard studs available here:https://www.morrisminorspares.com/engin ... s-p1238182 as a set or singly.
Or there are stud sets made by ARP but they are VERY expensive.
Stephen
Standard studs available here:https://www.morrisminorspares.com/engin ... s-p1238182 as a set or singly.
Or there are stud sets made by ARP but they are VERY expensive.
Stephen
1969 1098cc Convertible “Xavier” which I have owned since 1989.
Stephen
Stephen
-
- Minor Maniac
- Posts: 10881
- Joined: Thu Jul 19, 2012 12:05 pm
- Location: Hampshire
- MMOC Member: Yes
Re: HEAD STUDS
These are the studs you should be using:-
https://www.minispares.com/product/Clas ... o%20search
They can be torqued to 50 lbf.
https://www.minispares.com/product/Clas ... o%20search
They can be torqued to 50 lbf.