Morris Minor Owners Club

are the vernier plates for the torsion bar adjustment handed?
ca'nt seem to find a clear picture in the manuals and the ones i've seen all seem to be universal.
the ones ive taken of the car are both the same, could someone have messed up?

is the eye bolt thread 9/16 bsf. and is it better to use a spring washer and plane nut or the nylock type nut?

ive used a Clarke 135T for all my projects run off a 3 pin 13amp supply with no trouble at all using co2 gas. i managed to build a kit car from scratch with it . i would'nt be with out it. money well spent.[/img]<br><br>

both sills and a new floor to start usual rot on both front and back wheel arches. hints and tips welcome http://i770.photobucket.com/albums/xx346/mr-rusty/minor%20restoration/ol050.jpg http://i770.photobucket.com/albums/xx346/mr-rusty/ol023.jpg http://i770.photobucket.com/albums/xx346/mr-rusty/mino...

never wear specs. always wear goggles

has any one ever made a set of front window frames for a 2 door in stainless steel. all i ever seem to find are chrome plated steel ones that are advertised as stainless steel.
i always use the magnet test when i find a pair.
if it sticks its mild steel

after welding in a few new panels i have ground all the rust and underseal from the underside of the car back to shiny steel. i want to now put some form of protection on the car. on the underside and in the wheel arches. what can i use? whats best? what gives the best look? whats not messy to apply...

what to use on the underside to seal and protect.
after welding in a new floor and other panels the entire underside of the car has been ground back to bare shiny steel.every thing from the front bumper to the rear bumper.
suggestions welcome for a protective coating

if it aint shiny don't even consider it

what on earth are these
http://cgi.ebay.co.uk/ws/eBayISAPI.dll? ... K:MEWAX:IT

whats the thread size's for the brake pipe fittings on a 66 minor 1000 ?
will they be 10mm, 3/8 unc or 7/16 unc.
or am i missing the obvious

mogatron check out my project with this link to my photo bucket site http://s770.photobucket.com/albums/xx346/mr-rusty/ in my view if your going to get the angle grinder out, do it once. i opted to take the bull by the horns ( no pun intended) and take out the whole floor and sills on both sides. ex...