Morris Minor Owners Club

actually looking at the above picture, those doors have seen better days, i have 2 in the garage, not sure what they are like anymore, i put them in there about 8 years ago but they should be ok, i'll take a look if you want and take a picture

nice work, i'm galway based and have quite a few morris bits lying around from my own resto, let me know if you need anything.

guys tried a new coil, same problem drove for about 20 miles and dies again.

thankfully this time it left the new exhaust alone!!

I'll order a new condensor and see if that does it

yes

Folks, I have a few engine issues and I'm hoping that someone on here will point me in the right direction. I had a problem, the engine wasn't getting a spark. So Christmas eve i replaced the rotar arm, distributer cap, the points and off she went on the first run over. She was running very well she...

Folks,

I need to replace the chrome on my traveller, the replacement parts I got didn't last any length.

Is there a decent supplier out there from these part or am i better of trying to find good originals

George

thanks rob

Folks,

What is the definite product for treating this. I don't want to stain it just seal it.

I have tried a few products over the last few years but none last more than a few months.

George

front

and it needs replacing because its not there!! whoever did the bearings last never replaced it

George

Guys,

I need to replace the washer inside the hub retaining nut.

I checked the online parts suppliers and no-body has it listed

does anyone know the size of washer needed so i can source locally.

Regards,

George

big

let me get it first and then we'll talk

BTW the 1300cc marina autos come up on ebay quite a bit if your that interested in getting one

George

Lads,

Just a quick question. I might be able to get my hands on a 1300cc marina auto, the auto box won't make a difference will it. Its the engine alone i want.

Will it go in as easy as a 1300cc manual engine.

george

i just order the full coil-over kit from ESM so i'll let you know how that works out

i run a large car forum (www.cruiseirl.com) in ireland with a few buddys. we added a chat room to the site 6 months ago and it never took off

i think most people like forums

will, i think i need to move the front spline by one so, i'll take a few pics later and put them up for ye

if a front corner is high then the opposite rear corner will be low unless the car is bent or the ground is not flat. the rear passenger side is a little higher than the drivers alrght If the wheels are rubbing on the wings because the suspension is low, then the suspension is not the only problem ...

no they where labeled when they came out

its not a rear spring its local at the front

these are ESM kits so i don't know after that

i don't think the SPAX ones are adjustable

Folks I still haven't got the front suspension sitting right on the car. The passenger side is fine its the drivers side that the problem is. I have adjusted the left and right side the same, adjusted from the rear but when i put the car back on its wheels the passenger side retains its clearence, t...