Morris Minor Owners Club

I lost 2 of my fixings so I screwed the pins m5 & used m5 nuts & washers to secure
Regards
Brianr

attached photo

suggest you contact the spares man,Bryan Gostling,he had some series mm jacks at the National ralley earlier this year
Regards
BrianR

suggest you contact the spares man,Bryan Gostling,he had some series mm jacks at the National ralley earlier this year
Regards
BrianR

Thanks for your info folks,
BrianR

Can someone tell me when the rubber buffer between front wing & bumper valance came in to use & when it stopped,There are 2 off per wing.Its ESM part no EXC131
Thanks
BrianR

Hi there,
I used coverdale carpets & got a pretty good match, give them a ring & they will send you a catalogue & you can choose the colour & they will send samples.I still had my original carpets so used them as a template, phone no 01942 255535 or go on the net
Hope this helps
BrianR

Hi Les I had very similiar problems as you on the plumbing of my '52 mm, I then followed the workshop manual for the Series mm, its in section S under heater.The diagram very informative. With regard to the rad its taken a hammering,might be a thought to get it re-cored & then the fixings can be...

Hi I have used these studs,at the moment seem ok
http://www.wdsltd.co.uk/product/3220/ro ... l-wds-409/
Regards
BrianR

My series mm is September '52 & my engine no's are in exactly the same position
Regards
BrianR

Thanks for coming back
Bri

Hi all,
Can anyone tell me if the series mm had steel ferrules fitted to the bumper irons,which are mounted on the inner wings, if they were can you say where I can get hold of them.
Regards
BrianR

Hi Paul, I have a '52 series mm with water pump,to replace the pipe I bought some brass pipe 13mm dia & soldered a couple of brkts on at the required position to suit the head bolts & bobs your uncle,job done.If you look at the workshop manual for Seriesmm/Series 2 in section S page S2 you w...

received B33 fanbelt today fits ok
Bought it from Bearingsrus off the net
Regards
BrianR

Thanks 918,i have tried the B36 & it is way too big,have now bought a B33 & am awaiting delivery,
Regards
BrianR

Does anybody know where I can purchase a B33 belt for my series mm with waterpump
Regards
BrianR

Does anybody know where I can get the rubber sealing ring for the series mm oil filter.
Regards
BrianR

Guess what I have found the original split pulley in the loft of my garage & it fits perfectly so thanks again for your input & also Bryan Goslings .
Regards
BrianR

OK thanks Phil/Rob next challenge is to find one,do any of you have one spare?
Regards
Bri

The "spacer" is an integral part of the pulley,yes machining back level with the od of the pulley is an option but that will only gain me 5.0 mm,but infact it is the only option as turning the pulley around doesnt work as there is no shaft protrusion to secure,and once the pulley is hard u...