Wheel box installation
Forum rules
By using this site, you agree to our rules. Please see: Terms of Use
By using this site, you agree to our rules. Please see: Terms of Use
-
- Minor Fan
- Posts: 226
- Joined: Wed Aug 19, 2015 6:18 am
- Location: Nr. Newark
- MMOC Member: No
Wheel box installation
Hi wasn't sure which department to put this question in but here goes . I am fitting the wheel boxes to my 66 van I realise there is a gasket and chrome embellisher to go on the outside where the spindle comes through , should there be a rubber/ plastic spacer under neath the bulk head to enable the tightening of the spindle nut