Low Light Headlamp Parts

Discuss Electrical problems here.
Forum rules
By using this site, you agree to our rules. Please see: Terms of Use
Post Reply
Nourish
Minor Fan
Posts: 139
Joined: Wed Dec 17, 2014 5:42 pm
MMOC Member: No

Low Light Headlamp Parts

Post by Nourish »

On the 5 3/4" rims of the lowlight headlamps there are two pressed in holes - one either side that the lamp pivots on, is there supposed to be inserts in them?
Cheers
Nourish
Minor Fan
Posts: 139
Joined: Wed Dec 17, 2014 5:42 pm
MMOC Member: No

Re: Low Light Headlamp Parts

Post by Nourish »

RobThomas wrote: Sun Oct 02, 2016 11:23 am One side of the chrome ring has a rubber insert that swivels on the pin stuck in the outer edge of the lamp hole in the front panel. The inboard side of the chrome has a similar swivel but on a bracket that can slide fore-aft along the track welded to the inboard edge of the front panel and is clamped by a 2BA nut+bolt (I think that was the size?). The up-down is adjusted by the long screw thread in an obvious way although the thread is 180 degrees out in those pics. It enters the bodywork through a small hole below the lamp aperture, from the front.
Ah - found the above - I imagine that these rubbers aren't available - any body recommend something else to use?
Post Reply