Got any hints or tips? Share them here.
2 posts • Page 1 of 1
In the spring I replaced the swivel pins and trunnions on my pick up after 25 years service. Lots of us have done it and its not that difficult. But in March at the NEC I saw a guy struggling with a suspension change and where to put the jack under the trunnions to release the tension in the torsion bar. So I thought I put up a post showing the bracket I use to lift the suspension arm so that you can push out the lower trunnion pin. I use the same bracket to raise the suspension enough to get new grease in the trunnions. The bracket was made for me years ago and was bent using heat - not just cold hammered. The bracket is attached to the cast suspension arm once the pressed steel arm has been removed. The attachment uses the tie rod bolt and nut. The secret is to do it up so that it pinches but allows for movement when the jack is underneath.
- 1569168743_tmp_IMG_0319.jpg (1.23 MiB) Viewed 815 times
- 1569168687_tmp_IMG_0318.jpg (1.33 MiB) Viewed 815 times
- 1569168655_tmp_IMG_0317.jpg (645.35 KiB) Viewed 815 times
Who is online
Users browsing this forum: No registered users and 2 guests