Page 7 of 7
Re: What would that be?
Posted: Thu Aug 11, 2016 12:13 pm
by RobThomas
There are no kits, you just buy the bits you want to change.
http://www.morrisminorspares.com/
Re: What would that be?
Posted: Wed Aug 31, 2016 10:49 am
by pradeepprabhua
Hi,
Got the following items from the Spares man Mr Bryan.
Wiper motor, mount and brackets SH
Wiper drive cable, wheel boxes etc SH
Wiper arms black 2 no's
Rear brake cylinders Lockheed 2 No's
2 carbon brushes and springs for the distributor.
They shall be reaching here tomorrow.
Re: What would that be?
Posted: Sun Aug 20, 2017 2:31 pm
by pradeepprabhua
What is the nut thread size for the oil bath filter. Need to but a nut .
picture is as shown below.
Re: What would that be?
Posted: Tue Aug 22, 2017 11:54 am
by RobThomas
That filter only went to 'Export' countries so we don't have them in the UK. Can you measure the thickness of the metal rod and see how many turns of thread there would be in one inch of rod?
Re: What would that be?
Posted: Wed Sep 20, 2017 9:08 am
by TvdWerf
I checked it on my filters, it looks like 5 mm, but the metric 5 tapped does not go in the nut for more than a few windings.
So it must be the BSF thread , possible 3/16 " ?
Re: What would that be?
Posted: Wed Sep 20, 2017 10:47 am
by philthehill
The part number for the air cleaner wing nut is AAA3936 / 184825 (MOSS).
A plain washer and a spring washer is also fitted and are installed under the wing nut - plain washer against the top of the filter.
I would suggest that the wing nut required is 1/4" UNF or at most 5/16" UNF.