Does anyone know the material used for the manufacture of the head studs on the 918 sidevalve engine
Regards
BrianR
Head stud material
Forum rules
By using this site, you agree to our rules. Please see: Terms of Use
By using this site, you agree to our rules. Please see: Terms of Use
-
- Minor Fan
- Posts: 180
- Joined: Wed Aug 10, 2011 3:52 pm
- Location: Pembrokeshire
- MMOC Member: Yes
-
- Minor Legend
- Posts: 2646
- Joined: Thu May 11, 2006 10:34 am
- Location: Cardiff
- MMOC Member: Yes
Re: Head stud material
If it was carried over from the Morris 8 then it won't be anything special. Perhaps EN8 at best? If they are 10mm Mteric fine (Are they or is it just my memory) they may be available from another engine, if that is what you are thinking. Rolled threads would be nice but cut threads might be the only thing available.
If you find a source, I'd like to get some better ones for the Alta.
Cheers
Rob
If you find a source, I'd like to get some better ones for the Alta.
Cheers
Rob
Cardiff, UK
-
- Minor Addict
- Posts: 621
- Joined: Wed Sep 05, 2012 9:32 pm
- Location: East Yorkshire
- MMOC Member: Yes
Re: Head stud material
M10 x 1.5. Simple way is buy some M10 bolts 8.8 strength, cut to legnth and thread with a button die. Next up is 12.2 tensile, they would be more than enough. Put them in with "studloc"
-
- Minor Legend
- Posts: 3010
- Joined: Sun Sep 09, 2007 10:42 pm
- Location: Whiteabbey, Co Antrim
- MMOC Member: Yes
Re: Head stud material
I used cut down bolts when I rebuilt my MM and have done around 4000 miles now without issue, I was worried that they wouldnt be as strong as studs but it hasnt been a problem. The original had metric into the block and an imperial head!!
ESM do list them but at £7.95 each they seem rather expensive to me
http://morrisminorspares.co.uk/shop/pro ... c8f8a51823
ESM do list them but at £7.95 each they seem rather expensive to me
http://morrisminorspares.co.uk/shop/pro ... c8f8a51823
Too many Minors so little time.....
-
- Minor Fan
- Posts: 180
- Joined: Wed Aug 10, 2011 3:52 pm
- Location: Pembrokeshire
- MMOC Member: Yes
Re: Head stud material
Thanks for the info folks, I have found a site with m10 rolled high tensile studs which I am going to use
http://www.wdsltd.co.uk/product/3220/ro ... el-wds-409
Regards
BrianR
http://www.wdsltd.co.uk/product/3220/ro ... el-wds-409
Regards
BrianR
-
- Minor Fan
- Posts: 124
- Joined: Thu Jun 09, 2011 12:29 pm
- MMOC Member: No
Re: Head stud material
The studs sold by ESM are EN24T. Both threads are M10x1.5 as already said. Threads are cut, not rolled.
Colin
Colin
-
- Series MM Registrar
- Posts: 10183
- Joined: Sun Jul 24, 2005 11:39 pm
- Location: Reading
- MMOC Member: No
Re: Head stud material
Note, the threads are metric and the nut heads are 5/16 Whit, but you knew that already
[sig]3580[/sig]