Page 1 of 1
jacking point label
Posted: Tue Dec 17, 2019 2:09 pm
by seriesmm_1
Where does the jacking point label fit on the series mm, I got one off Rob Thomas but am unsure of its location
Regards
BrianR
Re: jacking point label
Posted: Tue Dec 17, 2019 2:25 pm
by JohnV
Ohhhhh ... could you post of a photo of the label? I think I vaguely recall Rob T making repro labels for something, not sure if it was that.
And I'm curious about the answer as well!
Re: jacking point label
Posted: Tue Dec 17, 2019 2:58 pm
by seriesmm_1
I haven't got a photo but if you go onto the series mm site on here & look under series mm porn & I think its page 3 you will see photos posted by Rob Thomas
Regards
BrianR
Re: jacking point label
Posted: Tue Dec 17, 2019 3:11 pm
by stevey
That label was usually tied to the screw jack in the toolkit I think.
Re: jacking point label
Posted: Tue Dec 17, 2019 3:13 pm
by JohnV
LOL, "Alta and MM porn," had missed that one! Searched the forum for "jacking" and found nothing about labels.
The porn thread did have pics of Rob's bonnet-lock and voltage-regulator labels, but nothing for jacking points ??
Re: jacking point label
Posted: Tue Dec 17, 2019 3:28 pm
by seriesmm_1
Page 5 of series mm porn
BrianR
Re: jacking point label
Posted: Tue Dec 17, 2019 3:37 pm
by JohnV
Aha! Much obliged, and thank you. I'm still many years away from labels for the 1949 "USA" Tourer, but a man can dream ... thanks again.
Re: jacking point label
Posted: Tue Dec 17, 2019 4:07 pm
by seriesmm_1
Stevey, that does seem the logical position to put the label, thanks
BrianR
Re: jacking point label
Posted: Tue Dec 17, 2019 8:26 pm
by Ian46
Just came upon this thread and thought I would post a picture of an original jacking instruction card I found under the back seat of my 1949 saloon and my attempt at reproducing a 'new' one for the finished restoration.
- DSCN6068.JPG (936.17 KiB) Viewed 1789 times