Case hardening?

for those with Series MM sidevalve cars produced between September 1948 and February 1953
Mick Lynch
Minor Fan
Posts: 150
Joined: Sat Sep 12, 2020 9:20 pm
MMOC Member: No

Case hardening?

Postby Mick Lynch » Fri Dec 17, 2021 4:06 pm

The adjuster screws on the tappets have a degree of wear and pitting. I have rubbed most of them flat with carborundum paste (checked them with blue for low spots and a hand mic to ensure they didn’t deviate from the perpendicular).

Should they be case hardened prior to re-erection?

If so it’s not something I have ever done; anyone got experience? Local ironmonger sells case hardening powder.
Attachments
D9EE34B0-A307-41B6-B340-6D27246F44AA.jpeg
D9EE34B0-A307-41B6-B340-6D27246F44AA.jpeg (2.51 MiB) Viewed 149 times

philthehill
Minor Maniac
Posts: 9513
Joined: Thu Jul 19, 2012 12:05 pm
MMOC Member: Yes

Re: Case hardening?

Postby philthehill » Fri Dec 17, 2021 4:40 pm

If you have the means of case hardening the adjuster screws they should be case hardened.
Here is a good explanatory video on case hardening:-
https://www.youtube.com/watch?v=f_bXiIfcBWs
An easy way of getting the heads of the tappets flat and square is to mount the tappet in a pillar drill chuck, put a piece of oiled emery cloth on the table and push down the chuck and tappet onto the oiled emery cloth. the head of the tappet will be smoothed and flat. Just make sure that the table is square to the chuck by mounting a piece of rod in the chuck and checking with a square on at least two sides.



Who is online

Users browsing this forum: No registered users and 1 guest