Hey folks,
I have just stripped, cleaned and replaced parts on my carb, I am now trying to resemble it, but can't work out how to get the two lever springs in the correct place to apply tension.
Has anyone got a photo or diagram showing them correctly assembled?
Thanks a lot!
Greg[frame][/frame]
Rebuilding SU HS2 carb and setting the lever springs
Forum rules
By using this site, you agree to our rules. Please see: Terms of Use
By using this site, you agree to our rules. Please see: Terms of Use
-
- Minor Friendly
- Posts: 31
- Joined: Thu Jul 18, 2013 9:23 am
- Location: Sunny Singapore
- MMOC Member: No
Rebuilding SU HS2 carb and setting the lever springs
Kevin the globe trotting 1956 two door
Re: Rebuilding SU HS2 carb and setting the lever springs
If you don't have one already - go to google and download a free copy of the 'morris minor workshop manual'
-
- Minor Legend
- Posts: 1092
- Joined: Sat Mar 14, 2009 2:50 am
- Location: Red Deer, Alberta, Canada
- MMOC Member: No
Re: Rebuilding SU HS2 carb and setting the lever springs
Talk slow, think fast!
Re: Rebuilding SU HS2 carb and setting the lever springs
Surely the idle adjust screw is in from the wrong side ??
-
- Minor Maniac
- Posts: 10794
- Joined: Thu Jul 19, 2012 12:05 pm
- Location: Hampshire
- MMOC Member: Yes
Re: Rebuilding SU HS2 carb and setting the lever springs
Fig 2 on the link provided by katy shows the lever(s) correctly fitted.
The spindle lever fitted to the carb in the above photo appears to have been fitted upside down and back to front.
The spindle lever fitted to the carb in the above photo appears to have been fitted upside down and back to front.
-
- Minor Friendly
- Posts: 29
- Joined: Tue May 28, 2013 5:25 pm
- Location: eynsford dartford
- MMOC Member: No
Re: Rebuilding SU HS2 carb and setting the lever springs
Hi you have probably solved it by now ,here is a pic ,just happened to have this one on the kitchen table,[frame][/frame]
-
- Minor Friendly
- Posts: 31
- Joined: Thu Jul 18, 2013 9:23 am
- Location: Sunny Singapore
- MMOC Member: No
Re: Rebuilding SU HS2 carb and setting the lever springs
Thanks folks, i have made some progress, corrected some dodgy screw fitment, but still not got my levers in the right place to start levering!
In the diagram below, i have tried to match the four ends of the levers to their correct lever points. Can someone check them and tell me if they are right?
[frame][/frame]
Apologies for the stupid question, i should have taken some photos when i disambled it, but it all sprung apart before i could check it!
Thanks a lot!
Greg
In the diagram below, i have tried to match the four ends of the levers to their correct lever points. Can someone check them and tell me if they are right?
[frame][/frame]
Apologies for the stupid question, i should have taken some photos when i disambled it, but it all sprung apart before i could check it!
Thanks a lot!
Greg
Kevin the globe trotting 1956 two door
Re: Rebuilding SU HS2 carb and setting the lever springs
Make sure you have the throttle plate in right way round..........