1) Can I line up using a 1098 primary input shaft /
2) Are these c£70 Thrust Bearing/Driven Plate / Pressure Plate kits any good, the old unipart etc sets used to be £100+ , so are these presumably budget clones worth the saving ?
3) Rather than the coil spring presure plates, are there better kits for saving my left foot a little.
4) Given that my problem appears to be lack of pull loaded uphill, rather than noticable slipping can I get away with adjusting the free play for now, or better to change before things become a true problem ( engine came with clutch that should have been my old one but the garage could have done anything without informing me )
948cc Clutch Assemblies New - Quality Issues?
Forum rules
By using this site, you agree to our rules. Please see: Terms of Use
By using this site, you agree to our rules. Please see: Terms of Use
-
- Minor Legend
- Posts: 2528
- Joined: Fri Aug 03, 2007 4:06 pm
- Location: stalbans
- MMOC Member: No
Re: 948cc Clutch Assemblies New - Quality Issues?
it the clutch says borg and beck its now made in china and rubbish qualiaty , get an ap driveline one
[sig]5641[/sig]
-
- Minor Legend
- Posts: 1904
- Joined: Sun Jul 03, 2011 11:37 am
- Location: Near Belper
- MMOC Member: Yes
Re: 948cc Clutch Assemblies New - Quality Issues?
Ring around some of the usual suspects and check out what they use?
Re: 948cc Clutch Assemblies New - Quality Issues?
Whyperion - please answer some of the PMs I have sent you about the dynamos you asked for..... I went to a lot of trouble to look them out for you, test them and parcel them up - and now silence from you .... Roy