Brake and clutch pedal return springs, where attached

[Michiel]

Around the brake and clutch pedals there are three identical looking return springs.

1. I know there is one between the clutch fork and a hole in the rear engine plate.
2. One from the exhaust clamp to where? A clevis pin? But which?
3. One from the master cylinder yoke to where?

I don 't remember. It was a year ago when I did take photo's, but not from these springs...

[dudload]

Around the brake and clutch pedals there are three identical looking return springs.

1. I know there is one between the clutch fork and a hole in the rear engine plate.
2. One from the exhaust clamp to where? A clevis pin? But which? One goes from the exhaust clamp to the accelerator yoke. This is the other part of the carb that doesn't have a cable going into it. (The choke should have a cable going into it already)
3. One from the master cylinder yoke to where? Assume you mean the brake pedal here? The spring goes to a small plate inside the chassis leg, and the other end to the brake pedal

I don 't remember. It was a year ago when I did take photo's, but not from these springs...

i've answered you're questions above!

[Michiel]

It is a new chassis leg, no plate inside. I will make one. Thanks Dudload.

[les]

Unusual not to have the spring fixing plate in the leg, makes you wonder if it got missed in production, it needs to be in the right place.

[Michiel]

LMC Hadrian and otherwise an absolute good leg...