Just been looking through my latest Cars and Car Conversions magazine September 1969 and picked up on an advert for Morris Minor negative camber damper arms (re)-manufactured by Ingham Engineering Ltd of Weybridge.
The damper arm is re-drilled to produce negative camber and is is on an exchange basis @ £8.10.0 per pair.
Anyone come across this conversion?
Ingham Engineering also advertised Torque arms (traction bars) and rear axle radius rod (Panhard rod) for the Minor.
Also available were 1" and 2" lowering blocks for the rear axle, steel centre main bearing caps for the 'A' Series engine and larger valves.
Morris Minor suspension
Forum rules
By using this site, you agree to our rules. Please see: Terms of Use
By using this site, you agree to our rules. Please see: Terms of Use
-
- Minor Maniac
- Posts: 10816
- Joined: Thu Jul 19, 2012 12:05 pm
- Location: Hampshire
- MMOC Member: Yes
-
- Minor Addict
- Posts: 759
- Joined: Sun Feb 01, 2009 6:24 am
- Location: New South Wales, Australia
- MMOC Member: Yes
Re: Morris Minor suspension
The mail is rather slow in your area, Phil.my latest Cars and Car Conversions magazine September 1969
Are there pictures in the advertisement?
Don
-
- Minor Maniac
- Posts: 10816
- Joined: Thu Jul 19, 2012 12:05 pm
- Location: Hampshire
- MMOC Member: Yes
Re: Morris Minor suspension
Don
Unfortunately no pictures of the replacement negative camber damper arms.
Back in the day C&CC was my regular magazine but over the years all went. I have rediscovered the magazine and am again an avid re-collector and reader especially those issues from the 1960s & 1970s. Lots of good articles and ideas even if they are years old.
Unfortunately no pictures of the replacement negative camber damper arms.
Back in the day C&CC was my regular magazine but over the years all went. I have rediscovered the magazine and am again an avid re-collector and reader especially those issues from the 1960s & 1970s. Lots of good articles and ideas even if they are years old.