Morris Minor Owners Club

Someone has very kindly left their mark on Dodo's front wing

It's done through the primer to the metal - should I just fill in with some touch up I have until I get some professional care next in about 10 day's time?[frame][/frame]

Yes just get it covered up with a compatible paint.Not primer it absorbs moisture.Dab it in with a small paintbrush.If you only have paint in an aerosol spray some in the lid then brush it on.

Was this a deliberate act? Looks like it, bas*^"ds

Cover it with grease out of your grease gun, this will keep oxygen out

Al

I wouldn't use grease. As above use a clean brush and cover all the bare metal with paint (celly) until you can get it professionally repaired.

I don't think it was malicious - but no one bothered to leave a note and it's not something you wouldn't have notice doing. Thanks all for the advice, I went to patch it with touch-up but found my pot had dried out and I don't have any thinners!

Just go to a motor shop and buy one of those small touch up plastic thingies witha brush in.As long as the colours similar.Will stop the rust till it gets done properly.

Looks quite deep

wouldn't use grease. As above use a clean brush and cover all the bare metal with paint (celly) until you can get it professionally repaired.





________
http://www.mybraindumps.net/642-832.html
http://www.uni-giessen.de/
http://www.juniper.net/
http://www.uchicago.edu/