Would anyone have an idea where I might be able to get one of the small plates that weld to the rear of the front inner wing panel that takes the screws for the door stay?
I have managed to loose the one I took off of the old panel and it's causing a major hold up now. It goes behind the two holes in the centre. Any advice would be most appreciated.
Thanks!
Front door stay screw plate
Forum rules
By using this site, you agree to our rules. Please see: Terms of Use
By using this site, you agree to our rules. Please see: Terms of Use
-
- Minor Friendly
- Posts: 86
- Joined: Tue May 24, 2005 12:42 pm
- Location: South East London
- MMOC Member: No
Front door stay screw plate
- Attachments
-
- mog99.PNG (638.51 KiB) Viewed 1361 times
-
- Minor Friendly
- Posts: 86
- Joined: Tue May 24, 2005 12:42 pm
- Location: South East London
- MMOC Member: No
Re: Front door stay screw plate
I don't have a tap and die set either or I'd make one!
Re: Front door stay screw plate
Might have a struggle there, two alternatives spring to mind. (1)make a plate. (2)fit the stay to the panel with the screws and appropriate nuts, then weld the two nuts to the back of the panel?
edit. Forget the first option then, I posted then saw your follow up message! you could though make a plate and weld nuts to that.
edit. Forget the first option then, I posted then saw your follow up message! you could though make a plate and weld nuts to that.
-
- Minor Friendly
- Posts: 86
- Joined: Tue May 24, 2005 12:42 pm
- Location: South East London
- MMOC Member: No
Re: Front door stay screw plate
Thanks Les, I think I'm just going to have to do that...
It's just one of those annoying little jobs that holds everything up!
All the best
It's just one of those annoying little jobs that holds everything up!
All the best
-
- Minor Friendly
- Posts: 86
- Joined: Tue May 24, 2005 12:42 pm
- Location: South East London
- MMOC Member: No
Re: Front door stay screw plate
Job done, 2 nuts welded on the back. all primered up and i can weld the pannel on next time i'm in the garage.