Removing set filler from a rubber handled screwdriver?

Discuss other problems here.
Forum rules
By using this site, you agree to our rules. Please see: Terms of Use
Post Reply
User avatar
Chief
Minor Addict
Posts: 602
Joined: Thu Apr 15, 2004 11:29 pm
Location: Lincs.
MMOC Member: Yes

Removing set filler from a rubber handled screwdriver?

Post by Chief »

Hi,
Has anyone got any suggestions for removing hardened filler from a rubber handled screwdriver from both the handle and metal blade without damaging the screwdriver?

Thanks,
Chief.
mogbob
Minor Legend
Posts: 1280
Joined: Thu Apr 02, 2009 3:43 pm
Location: Esher
MMOC Member: No

Re: Removing set filler from a rubber handled screwdriver?

Post by mogbob »

If the rubber element of the handle is generous you might be able to gently " squeeze " the handle rubber bit enough to " crack " the filler. Wind up the vice , a little at a time and rotate a fraction each time i.e don't try it in one go. Wrap the handle in an old piece of cloth. Scrape off the remnants with a small trimming knife and clean off with a bit cloth and Meths.
Screwdriver blade , just gently scrape with a chisel , towards the handle. If the rubber element encases the end /bottom where it meets the blade consider using masking tape to protect the rubber from the chisel blade.
Bob
philthehill
Minor Maniac
Posts: 10767
Joined: Thu Jul 19, 2012 12:05 pm
Location: Hampshire
MMOC Member: Yes

Re: Removing set filler from a rubber handled screwdriver?

Post by philthehill »

It might be worth while considering buying a new screw driver!!!!!!!!!!!!!!

les
Minor Maniac
Posts: 8737
Joined: Tue Feb 12, 2002 12:00 am
Location: kent
MMOC Member: Yes

Re: Removing set filler from a rubber handled screwdriver?

Post by les »

:D

User avatar
Chief
Minor Addict
Posts: 602
Joined: Thu Apr 15, 2004 11:29 pm
Location: Lincs.
MMOC Member: Yes

Re: Removing set filler from a rubber handled screwdriver?

Post by Chief »

Thanks mogbob, sounds like a good solution to try - shame my chisel also got a bit covered by the stuff too :D

philthehill, where's the fun in that?! (also that would cut into my limited remaining budget too much).

Chief :)
philthehill
Minor Maniac
Posts: 10767
Joined: Thu Jul 19, 2012 12:05 pm
Location: Hampshire
MMOC Member: Yes

Re: Removing set filler from a rubber handled screwdriver?

Post by philthehill »

Better to cut into your budget instead of your hand with a small trimming knife or chisel. :D

JenniferT
Newbie
Posts: 4
Joined: Thu Jan 25, 2018 5:30 am
MMOC Member: No

Re: Removing set filler from a rubber handled screwdriver?

Post by JenniferT »

Hi,
May be its worth, to considering buying a new screw driver!
Post Reply