Seat cover help.
Posted: Wed Feb 20, 2019 7:07 am
I've just rebuilt my drivers seat with new straps & foam which went ok, even getting the new straps on wasn't too bad. But that stupid rubber strip which pushes into the groove underneath to hold the base cover in place is infuriating!
I get part of it in & the start pops out, the corners wont go in at all . Is there a trick to doing this that I'm missing? Very close to just throwing away the rubber strip & using some of the spring clips around the edges.
Thanks.
I get part of it in & the start pops out, the corners wont go in at all . Is there a trick to doing this that I'm missing? Very close to just throwing away the rubber strip & using some of the spring clips around the edges.
Thanks.