Hi
My friends , how you set(hang) the Morris ''Minor 1000'' badge to bonnet side , there are no Screws , it is clip model , how you set them ? Any pic have you ?
Regards
Sandun
How to set the bonnet side badges
Forum rules
By using this site, you agree to our rules. Please see: Terms of Use
By using this site, you agree to our rules. Please see: Terms of Use
Re: How to set the bonnet side badges
Sandum
You will need two spire clips ( for each badge ) which push on from the inside of the bonnet. If you use a small socket , you can push the clip over the "stud " part of the badge that goes through the holes in the bonnet.
See relevant page from the Moss catalogue https://www.moss-europe.co.uk/shop-by-m ... minor.html Spire clips are item 12.
Bob
You will need two spire clips ( for each badge ) which push on from the inside of the bonnet. If you use a small socket , you can push the clip over the "stud " part of the badge that goes through the holes in the bonnet.
See relevant page from the Moss catalogue https://www.moss-europe.co.uk/shop-by-m ... minor.html Spire clips are item 12.
Bob
Re: How to set the bonnet side badges
or cut ends off ball point pen insert,and push plastic tube onto peg,did mine like that twenty years ago,still there
-
- Minor Legend
- Posts: 2536
- Joined: Tue Jan 29, 2013 10:32 pm
- Location: Kernow
- MMOC Member: Yes
Re: How to set the bonnet side badges
Yes, or any similar size plastic tubing........good news is that this can't rust! Can't remember what I used on mine, something suitable I had lying around.................
-
- Minor Legend
- Posts: 2953
- Joined: Mon May 16, 2016 4:39 pm
- Location: Kidderminster, Worcestershire.
- MMOC Member: Yes
Re: How to set the bonnet side badges
You may be able to get some plastic 'top-hat' fixings. Here in the UK they cost a few pence each and will afford rust protection. They push into the holes from the outside. There will be a very small gap between the badge and the bonnet but this should reduce the build-up of dirt behind the badge.
1956 4-door called Max
Re: How to set the bonnet side badges
or a dab of mastic behind which would also seal up the hole to stop rust
Re: How to set the bonnet side badges
Kennatt ,
Some useful tips there , thanks. ( The combined power of the Forum in action , is a wonderful thing ! We all learn that little bit more each time).
Bob
Some useful tips there , thanks. ( The combined power of the Forum in action , is a wonderful thing ! We all learn that little bit more each time).
Bob
-
- Minor Fan
- Posts: 404
- Joined: Tue Nov 08, 2016 1:38 pm
- Location: Yanbu Al-Sinaiyah, Saudi Arabia (temporary posting)
- MMOC Member: Yes
Re: How to set the bonnet side badges
Mine are held on by a lump of silicon sealant on the back. (Previous owner’s work)
But it looks horrible and I’ll fix it when I have time.
But it looks horrible and I’ll fix it when I have time.
Brian
"Jodie". '67 Traveller, 1275, discs, suspension mods etc.
"Jodie". '67 Traveller, 1275, discs, suspension mods etc.