Hi,
I am rebuilding my USHM2 engine and am approaching the point where I need to remove the camshaft. In order to do this, the distributor drive dowel needs to be extracted.
Is anyone able to advise the specific bolt/screw I need in order to do this? The manual advises that this is 5mm but I am unsure of the thread pitch.
Many thanks.
Ryan
Side valve engine: extraction of distributor drive dowel
Forum rules
By using this site, you agree to our rules. Please see: Terms of Use
By using this site, you agree to our rules. Please see: Terms of Use
Re: Side valve engine: extraction of distributor drive dowel
Hi Ryan,
The distributor drive dowel thread on the USHM2 side-valve engine is M5 x 0.8mm pitch.
sirrom918
The distributor drive dowel thread on the USHM2 side-valve engine is M5 x 0.8mm pitch.
sirrom918