Morris Minor Owners Club

I wasn't sure where to post this one but....

doe's anyone know how I would go about either lowering or getting a 2 door saloon lowered? is this possible? and if so how much hassle is it?

Thanks alot

VERY easy.

You don't need any modification parts to lower the front. Either adjust the torsion bar adjuster next to the main chassis crossmember, and / or turn the torsion bars one spline to give further adjustment.

To lower the back you just need lowering blocks which fit in between the axle and springs (available from most Minor places).

Thanks alot Cam, muchly apreciated

I thought the days of lowered cars were over, with the introduction of speed humps, better fit a sump guard!

Mine is lowered by about 1 1/2 - 2 inches at the front. Not too radical, and the rear is standard height. (I like the stanced look).

It does not look lowered when standing on it's own, only when parked next to standard ride height Moggies.

Thats what I'm thinking for my mog a nice stance nothing over the top just an inch or so

If that height is OK for you then just move the torsion bars by one spline each and that should give you the required stance!

Mmmmmmmm......stance.......

Brilliant

Thanks Cam