Hello and Happy New Year to everybody from Paul in Yuma, Arizona. Attached is a photo showing just a little less than 1/8" travel between the carbon ring and the thrust plate on the pressure plate of my 1952 Series MM, is this correct. It just seems a very small distance to me.
Regards,
Paul. manlyvaleaussie
Clutch problem
Forum rules
By using this site, you agree to our rules. Please see: Terms of Use
By using this site, you agree to our rules. Please see: Terms of Use
-
- Minor Friendly
- Posts: 65
- Joined: Tue Mar 20, 2018 10:41 pm
- MMOC Member: No
Clutch problem
- Attachments
-
- DSC01699.JPG (173.28 KiB) Viewed 2308 times
-
- DSC01698.JPG (173.36 KiB) Viewed 2308 times
-
- Minor Maniac
- Posts: 10818
- Joined: Thu Jul 19, 2012 12:05 pm
- Location: Hampshire
- MMOC Member: Yes
Re: Clutch problem
If you have a 1/8" you are on the right side of things.
The workshop manual Section E . Fig. E.1 shows the minimum clearance as 1/16" minimum.
Happy New Year to you and all those reading this.
Phil
The workshop manual Section E . Fig. E.1 shows the minimum clearance as 1/16" minimum.
Happy New Year to you and all those reading this.
Phil
-
- Minor Friendly
- Posts: 65
- Joined: Tue Mar 20, 2018 10:41 pm
- MMOC Member: No
Re: Clutch problem
Thank you for such a prompt reply Phil, greatly appreciated.
Paul.
Paul.