Hi
I am going to fit a 1098 ribbed box into my 1954 car. I have a replacement tunnel cover and could work out how much to cut out but to save me making a mistake does anyone know how much (measurements) I need to elongate the hole in the floor by?
If someone has made a note of what needs cutting out then that would be much appreciated and probably very useful to post up on this site, for anyone else who is about to attempt the same change to theirs.
As always many thanks in advance for any help / advice given.
Best wishes,
Mike.
Tunnel alteration
Forum rules
By using this site, you agree to our rules. Please see: Terms of Use
By using this site, you agree to our rules. Please see: Terms of Use
-
- Minor Legend
- Posts: 3635
- Joined: Fri Apr 11, 2008 7:28 pm
- Location: Mansfield, Nottinghamshire.
- MMOC Member: Yes
Tunnel alteration
1954 Series 2: 4 door: "Sally" -- Back on the ground with (slave) wheels and waiting to be resprayed......
1970 Triumph Herald 1200: "Hetty" -- Driven back from Llangollen in Wales (twice.....)
1970 Triumph Herald 1200: "Hetty" -- Driven back from Llangollen in Wales (twice.....)
-
- Minor Addict
- Posts: 621
- Joined: Wed Sep 05, 2012 9:32 pm
- Location: East Yorkshire
- MMOC Member: Yes
Re: Tunnel alteration
I modified my series MM about 20 years ago and cut 1&1/2" from the floor. When I converted it back to side valve I just welded the piece back in. I had changed the cross member for the gear box also the propshaft and rear axle. The 1275cc MG engine is in my pick up now.